Five-metre extension
Useful when the sunny panel position and light position are separated. Allow for routing, a drip loop and strain relief; the cable should not carry tensile load.
HEY LIGHTING · HL-AC-003 · SOLAR ACCESSORY · 5 M CABLE · KEYED TWO-PIN CONNECTOR
5 m Two-Pin Solar Extension Cable HL-AC-003
An extension cable for increasing the distance between a solar panel and a compatible low-voltage light or controller. It has keyed two-pin male and female connectors with threaded locking collars. Always compare the real connector and electrical specifications before use.
Request quoteby connector, light model and quantity
Send clear photos of both existing connector ends, the light model and quantity through LINE for a compatibility check and quotation.
- HEY SKU
- HL-AC-003
- Brand
- HEY Lighting
- Type
- Extension cable for low-voltage solar-light systems; not an AC mains cable
- Length
- 5 m
- Connector
- Keyed two-pin male and female ends with threaded collars
- Voltage
- For low-voltage solar-light systems up to 36 V; all system values must match
- Use
- Extends the distance between a solar panel and a compatible light or controller
Use only with a verified low-voltage solar-light system. Never connect this cable to 220/230V mains, and never assume interchangeability from “two-pin” or “universal” wording alone. Confirm connector geometry, alignment key, pin spacing, polarity, voltage and maximum current across the panel, cable and light before ordering. Additional cable length creates voltage drop, which cannot be calculated until resistance and real load current are known.
Add 5 metres of installation distance
Place the panel where it receives useful sunlight and route the cable to the required light position, with matching connectors and electrical values throughout the system.
Keyed connector geometry
The imagery shows a two-pin male end and a shaped female receptacle. The key may reduce reversed insertion, but keying and pinout still require comparison with the real equipment.
Threaded locking collar
Tighten the collar to reduce separation from pulling or vibration, and keep the connection away from standing or submerged water.
Check three things before connection
Send a clear photo of the existing connector together with the solar-panel and light models. A connector that fits may still be electrically incompatible.
Connector geometry and dimensions
Compare pin count, alignment key, thread, diameter and insertion depth. Never force the connector or bend pins to make it fit.
Voltage, polarity and current
Confirm nominal voltage, positive/negative pin assignment and maximum system current. This is not a mains cable, and no 800W rating has been verified.
Effect of cable length
Longer cable adds resistance and voltage drop. Measure voltage at the load under operating current, especially for higher-power sets or multiple extensions.
Do not daisy-chain multiple extensions without checking total length, load current and voltage at the light under real operating conditions.
Review the cable and connector details
Use the images for an initial shape comparison, then send clear photos of both existing connector ends before ordering.
